Low-Cost High-Speed Photography - Part 3




Find this and other photos HERE.





The Final Hardware


And here is the final part of the entry, starting with the schematic that I finally used. The core is the same as before. But now there is a linear voltage regulator for the controller. Also shown here is the serial interface and most importantly, the sensor circuit.





The sensor circuit consists of two parts. First, the reference

Comments

Post a Comment

Popular posts from this blog

Different Types of Plastics- Advantages and Disadvantages

Plastics can be classifies into two broad categories - Thermosets and Thermoplasctics. A brief description of these two classes will be discussed here. Thermosets are the kind of plastics which are not recyclable. They undergo a kind of chemical change at the time of heating. As a result they can be shaped once because of this permanent chemical change. This process is known as heat hardening.
Read more

A Low-Cost EggPlotter

Features Plots on spheres and eggs, similar to the EggBot Uses low-cost components (total cost around 25 €) Software is written as an Arduino sketch But: NOT as accurate as the original EggBot Introduction I have admired the idea of the EggBot for quite some time. The original device is an art project of Bruce Shapiro, apparently conceived in 1990. Read about the history of it
Read more

Earthing as Per Indian Standard IS 3043:1987

Image
Earthing is very important part in every electrical system below are earthing pits design which are self explanatory:- Earthing with copper plate:- GI earthing system:- Pipe earthing:- Above Pics describe how to design earthing pits in electrical systems as per Indian Standard IS 3043:1987
Read more