The Charlie Cube Mark II: 4x4x4


















Project Features



Minimal hardware
Wiring more complex than standard led cubes
LED duty cycle 1/8


Update: There is a schematic and part list available here.

WARNING: Do not build this cube unless you know what you are doing! It uses minimal hardware but is difficult to understand.

There is a new design which is much easier to build with a very low part count.



Comments

Post a Comment

Popular posts from this blog

Different Types of Plastics- Advantages and Disadvantages

Plastics can be classifies into two broad categories - Thermosets and Thermoplasctics. A brief description of these two classes will be discussed here. Thermosets are the kind of plastics which are not recyclable. They undergo a kind of chemical change at the time of heating. As a result they can be shaped once because of this permanent chemical change. This process is known as heat hardening.
Read more

Earthing as Per Indian Standard IS 3043:1987

Image
Earthing is very important part in every electrical system below are earthing pits design which are self explanatory:- Earthing with copper plate:- GI earthing system:- Pipe earthing:- Above Pics describe how to design earthing pits in electrical systems as per Indian Standard IS 3043:1987
Read more

A Low-Cost EggPlotter

Features Plots on spheres and eggs, similar to the EggBot Uses low-cost components (total cost around 25 €) Software is written as an Arduino sketch But: NOT as accurate as the original EggBot Introduction I have admired the idea of the EggBot for quite some time. The original device is an art project of Bruce Shapiro, apparently conceived in 1990. Read about the history of it
Read more