A USB/ISP Programmer (Part 1)






Introduction



When I started this blog I meant to do so mainly in order to document my own projects. I found that when I wanted to re-use parts of one of my projects I sometimes couldn't remember why I had made certain decisions. So I needed to document my work. And if anyone else could benefit from it, why not publish all in a blog?



But I never intended to bore anybody with my opinions

Comments

Post a Comment

Popular posts from this blog

Earthing as Per Indian Standard IS 3043:1987

Image
Earthing is very important part in every electrical system below are earthing pits design which are self explanatory:- Earthing with copper plate:- GI earthing system:- Pipe earthing:- Above Pics describe how to design earthing pits in electrical systems as per Indian Standard IS 3043:1987
Read more

Low-Cost High-Speed Photography - Part 1

Find this and other photos HERE. Project Features Produces white light flashes for high-speed photography and multiple exposures High flexibility / reconfigurability (menu controlled) Low cost (no flash unit needed, mostly cheap parts) Simple hardware No recharging time as for conventional flash lights Introduction Some of the ideas I have take years until I actually put them into practice
Read more

Electrical Contactors AC1, AC2, AC3, AC4

Image
Electrical Contactors Utilization Categories:- Electrical Contactors are categorized according to the current making and breaking values for contactors. This will depend on the following: The type of load to be controlled (Inductive load, Lighting load, Motor load, Resistive load, Capacitive load) The operating cycle conditions. For any applications there are different contactors available depending upon load application which every electrical engineer you must know before designing any systems.  You may have often seen the ratings described on contactor name plate depicting various parameters. One of most important to be considered are as described in this article.  AC1 - These type of contactors are used for Non-inductive or slightly inductive loads they are used for Heaters which are resistive loads. AC2 - These type of contactors are used in Starting of slip-ring motors AC3 – They are particularly used for Starting of squirrel-cage motors and sw...
Read more