How to Do ISP Programming – Part 2: Hardware Considerations




What Hardware do I need?
Obviously you need the controller. This can be any Atmel ATtiny or ATMega. You need a circuit board to put the controller in (the "target board") and you need an ISP programmer. Since ISP uses a serial format, the programmer can be rather compact.


There is a wide variety of programmers on the market, from full featured expensive to cheap and simple. Since

Comments

Post a Comment

Popular posts from this blog

Plastic Extrusion Process Principles

Extrusion Process Principles Extrusion process is very common in the plastic industry. It is used for high volume plastic production. In extrusion process the color pigments along with other performance enhancing additives are combined with resin which is then pushed through the rotating screws. The heat and pressure generated within the barrels of screw is dispersed and melts the plastic
Read more

Earthing as Per Indian Standard IS 3043:1987

Image
Earthing is very important part in every electrical system below are earthing pits design which are self explanatory:- Earthing with copper plate:- GI earthing system:- Pipe earthing:- Above Pics describe how to design earthing pits in electrical systems as per Indian Standard IS 3043:1987
Read more

Different Types of Plastics- Advantages and Disadvantages

Plastics can be classifies into two broad categories - Thermosets and Thermoplasctics. A brief description of these two classes will be discussed here. Thermosets are the kind of plastics which are not recyclable. They undergo a kind of chemical change at the time of heating. As a result they can be shaped once because of this permanent chemical change. This process is known as heat hardening.
Read more