The Morse Thermometer - Part 3


Putting it all together
In part 1 and part 2 of this posts I investigated and designed the components for a solar-powered Morse thermometer. In part 3 everything gets connected.

In order to get the most out of the collected sunlight it is important to use as little power as possible. A red LED is a good choice here, because it only has a forward voltage of 1.7 Volts. So it will consume only

Comments

Post a Comment

Popular posts from this blog

Earthing as Per Indian Standard IS 3043:1987

Image
Earthing is very important part in every electrical system below are earthing pits design which are self explanatory:- Earthing with copper plate:- GI earthing system:- Pipe earthing:- Above Pics describe how to design earthing pits in electrical systems as per Indian Standard IS 3043:1987
Read more

LED Photos

OK, this one isn't really a project. But I wanted to share it anyway. One day a bought this little ...light thingy in a junk shop. I didn't really know what it was, but it had LEDs and anyway it was only 1 €... This is what it looks like: It turns out that it has three very bright LEDs in red, green and blue and it works in different modes; one of them is a colour change mode. But it does this
Read more

Electrical Contactors AC1, AC2, AC3, AC4

Image
Electrical Contactors Utilization Categories:- Electrical Contactors are categorized according to the current making and breaking values for contactors. This will depend on the following: The type of load to be controlled (Inductive load, Lighting load, Motor load, Resistive load, Capacitive load) The operating cycle conditions. For any applications there are different contactors available depending upon load application which every electrical engineer you must know before designing any systems.  You may have often seen the ratings described on contactor name plate depicting various parameters. One of most important to be considered are as described in this article.  AC1 - These type of contactors are used for Non-inductive or slightly inductive loads they are used for Heaters which are resistive loads. AC2 - These type of contactors are used in Starting of slip-ring motors AC3 – They are particularly used for Starting of squirrel-cage motors and sw...
Read more