A Low-Cost EggPlotter












Features

Plots on spheres and eggs, similar to the EggBot
Uses low-cost components (total cost around 25 €)
Software is written as an Arduino sketch
But: NOT as accurate as the original EggBot



Introduction

I have admired the idea of the EggBot for quite some time. The original device is an art project of Bruce Shapiro, apparently conceived in 1990. Read about the history of it

Comments

Post a Comment

Popular posts from this blog

Earthing as Per Indian Standard IS 3043:1987

Image
Earthing is very important part in every electrical system below are earthing pits design which are self explanatory:- Earthing with copper plate:- GI earthing system:- Pipe earthing:- Above Pics describe how to design earthing pits in electrical systems as per Indian Standard IS 3043:1987
Read more

LED Photos

OK, this one isn't really a project. But I wanted to share it anyway. One day a bought this little ...light thingy in a junk shop. I didn't really know what it was, but it had LEDs and anyway it was only 1 €... This is what it looks like: It turns out that it has three very bright LEDs in red, green and blue and it works in different modes; one of them is a colour change mode. But it does this
Read more

Electrical Contactors AC1, AC2, AC3, AC4

Image
Electrical Contactors Utilization Categories:- Electrical Contactors are categorized according to the current making and breaking values for contactors. This will depend on the following: The type of load to be controlled (Inductive load, Lighting load, Motor load, Resistive load, Capacitive load) The operating cycle conditions. For any applications there are different contactors available depending upon load application which every electrical engineer you must know before designing any systems.  You may have often seen the ratings described on contactor name plate depicting various parameters. One of most important to be considered are as described in this article.  AC1 - These type of contactors are used for Non-inductive or slightly inductive loads they are used for Heaters which are resistive loads. AC2 - These type of contactors are used in Starting of slip-ring motors AC3 – They are particularly used for Starting of squirrel-cage motors and sw...
Read more